Emerson Process Management 2400S manual Meter

Device Profile

Table C-7Diagnostics Object (0x66) – Instance 1 continued

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
55	Meter	USINT	Get	V	The reason the meter	• 0 = No error
	verification abort				verification routine	• 1 = Manual abort
	code				aborted	• 2 = Watchdog timeout
						• 3 = Frequency drift
						• 4 = High peak drive
						voltage
						• 5 = High drive current
						standard deviation
						• 6 = High drive current
						mean
						• 7 = Drive loop
						reported error
						• 8 = High Delta T
						standard deviation
						• 9 = High Delta T
						value
						• 10 = State running
						• 11 = Verification
						complete
						• 12 = Wrong
						verification enable
						• 13 = No factory air
						verification
						• 14 = No factory water
						verification
						• 15 = Parameters not
						set
56	Meter	USINT	Get	V	The state of the meter	1–18
	verification				verification routine when it
	algorithm state				aborted
	at abort
57	Meter	USINT	Get	V	The progress of the meter	%
	verification				verification routine
	percent
	complete
58	Meter	USINT	Set	NV	The state of the outputs	• 0 = Last value
	verification				when the meter	• 1 = Fault
	outputs state				verification routine is
					running
59	Meter	REAL	Set	NV	The setpoint of the	Unitless
	verification				stiffness limit. Represents
	stiffness limit				percentage.
60	Meter	UINT	Get	NV	Indicates the number of
	verification				times the meter
	validation				verification routine has
	counter				successfully completed
61	Meter	USINT	Get	V	Is the inlet stiffness out of	• 0 = No
	verification inlet				limits?	• 1 = Yes
	stiffness out of
	limits
62	Meter	USINT	Get	V	Is the outlet stiffness out	• 0 = No
	verification				of limits?	• 1 = Yes
	outlet stiffness
	out of limits

156 Micro Motion® Model 2400S Transmitters for DeviceNet™