Connecting with ProLink II or Pocket ProLink Software
4.4.4Connecting via the IrDA port
Note: The IrDA port is typically used with Pocket ProLink. To use the IrDA port with ProLink II, a special device is required; the IrDA port built into many laptop PCs is not supported. For more information on using the IrDA port with ProLink II, contact Micro Motion customer service.
To connect to the service port via the IrDA port:
1.Ensure that the IrDA port is enabled (see Section 8.10.6). By default, the IrDA port is disabled.
2.Ensure that there is no connection via the service port clips.
Note: Connections via the service port clips have priority over connections via the IrDA port. If you are currently connected via the service port clips, you will not be able to connect via the IrDA port.
3.Position the IrDA device for communication with the IrDA port (see Figure
4.Start Pocket ProLink software. In the Connection menu, click Connect to Device. In the screen that appears, specify:
•Protocol: Service Port
•IrDA Port
No other parameters are required.
5. Click Connect. The software will attempt to make the connection.
Note: While you are connected to the IrDA port, both optical switch indicators will flash red, and both the Scroll and Select optical switches are disabled.
6.If an error message appears:
a.Ensure that you are using the correct port.
b.Ensure that the IrDA port is enabled.
4.5ProLink II language
ProLink II can be configured for the following languages:
•English
•French
•German
To configure the ProLink II language, use the Tools menu. See Figure
In this manual, English is used as the ProLink II language.
20 | Micro Motion® Model 2400S Transmitters for DeviceNet™ |
