Emerson Process Management 2400S manual Table C-3Analog Input Point Object 0x0A Instance 3 density

Device Profile

Table C-2Analog Input Point Object (0x0A) – Instance 2 (liquid volume flow)

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
3	Value	REAL	Get	V	Current value of liquid	Based on Attribute 8
					volume flow process
					variable
4	Status	BOOL	Get	V	Point status	• 0 = Good
						• 1 = Alarm state
8	Value data type	USINT	Get	V	Data type used to report	1 (REAL)
					volume flow process
					variable
100	Process total	REAL	Get	V	Current value of liquid
			Reset(1)		volume total
101	Inventory total	REAL	Get	V	Current value of liquid
			Reset(2)		volume inventory
102	Value	UINT	Set	NV	Liquid volume flow	See Table 6-3for unit
	engineering				measurement unit	codes.
	units
103	Total	UINT	Get	V	Liquid volume total and	Transmitter
	engineering				inventory units	automatically
	units					determines this based
						on Attribute 102.
						See Table C-13for unit
						codes.
105	Cutoff	REAL	Set	NV	Value below which liquid
					volume flow will be
					reported as 0
106	Meter factor	REAL	Set	NV	A multiplier to the
					calculated liquid volume
					flow
108	Reset volume	USINT	Set	V	Resets the volume total	• 1 = Reset
	total
109	Reset volume	USINT	Set	V	Resets the volume	• 1 = Reset
	inventory				inventory

(1)Service code 0x4B.

(2)Service code 0x4C.

Table C-3Analog Input Point Object (0x0A) – Instance 3 (density)

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
3	Value	REAL	Get	V	Current value of density	Based on Attribute 8
					process variable
4	Status	BOOL	Get	V	Point status	• 0 = Good
						• 1 = Alarm state
8	Value data type	USINT	Get	V	Data type used to report	1 (REAL)
					density process variable
102	Value	UINT	Set	NV	Density measurement unit	See Table 6-5for unit
	engineering					codes.
	units

Menus

Device Profile

Display Codes

Index

Configuration and Use Manual 145