Mobility Configuration Menu
Mobility Configuration Menu
A) BSP Routing Enable | disabled |
B) IAPP Enable | disabled |
C) Unit Update Enable | enabled |
D) IAPP Multicast Address | 244.254.1.1 |
E) IAPP Multicast Port | 39990 |
F) IAPP Multicast TTL | 1 |
G) IAPP Unicast Port | 39990 |
Select a letter to configure an item, <ESC> for the prev menu
▪BSP Routing Enable—This parameter controls intra-cell transmission and routing of Basic Serial Protocol packets.[Enabled, Disabled; Disabled]
▪IAPP Enable—This parameter enables the Inter-Access Point Protocol (IAPP), which allows APs to pass payload data over the Ethernet LAN. [Enabled, Disabled; Disabled]
▪Unit Update Enable—This parameter allows the AP to immediately send out an IAPP update when a Remote connects or disconnects. [Enabled, Disabled; Disabled]
▪IAPP Multicast Address—An address that allows multicast messaging to travel to all radios in a subnetwork (all radios with a common network address). [224.254.1.1]
▪IAPP Multicast Port—An assigned software port that allows mul-ticast messaging to travel to all radios in a subnetwork (all radios with a common network address). [39990]
▪IAPP Multicast TTL—Multicast “time to live” number. This is the number of hops that a message is allowed to make before it is no longer transportable. This feature prevents “infinite life” packets that degrade system performance. [1-15; 1]
▪IAPP Unicast Port—An address that allows messaging to travel to a specific radio when that message has originated from another subnetwork. [39990]
3-16 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489