GE GFK-2489 user manual Remote Serial Gateway Configuration IP-to-Remote Serial

3

Remote Serial Gateway Configuration (IP-to-Remote Serial)

The Remote Serial Gateway Menu controls the IP encapsulation behavior of all Remote radios. The gateway function is essentially a table with one entry for each Remote radio passing serial data. No further configuration is required at Remote radios.

The AP can be configured to accept IP traffic to be exchanged with devices connected to the serial ports of one or more Remotes. The screen below shows the starting point for configuring the remote serial gateway settings.

Remote Serial Gateway Menu

A) RSG TalkBack Enable	enabled
B) RSG TalkBack Timeout	30 seconds

C)RSG Entries

D)Remote Serial Wizard

Select a letter to configure an item, <ESC> for prev menu

▪RSG Talkback Enable (UDP IP-to-Serial)—When Talkback is enabled and the RSG is set up for UDP mode, a message from a Remote radio (usually a reply to a poll) is sent to the last IP address or port that a message was received from. [Enabled, Disabled; Enabled]

▪RSG Talkback Timeout—This selection is used to set a time limit after which, if no data has been received from the IP host, the RSG talkback feature expires. When this happens, the RSG reverts to its configured IP address and port for upstream data destined for an IP host. [Time in seconds; 30]

3-30 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489