AUTH Displays the list of authorized features, or changes the Authorization Key that controls these features.
Optional arguments:
KEY=<key>—Enter a valid authorization key (1–16 characters), which is used to enable or disable software features.
(Example: AUTH KEY=123456abcdef)
CMD—Displays all settable optional arguments and their current values. You can copy this list to a text file as a record of your configuration.
COM1 Optional arguments:
BAUD=<bps>—Sets or displays the baud rate setting as 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps.
BUFFER=<bytes>—Sets or displays the maximum COM1 port buffer size (1– 1500).
CMD—Displays all settable optional arguments and their current values. You can copy this list to a text file as a record of your configuration.
DEFAULT=<mode>—Sets or displays the COM1 port default mode on startup. DEFAULT cannot be set to DATA unless the device has been authorized for serial payload.
CONSOLE: COM1 defaults to command-line mode
DATA: | COM1 | defaults to transparent data mode |
BSP: | COM1 | defaults to in Basic Serial Protocol mode |
INT_LOOP: COM1 defaults to internal loopback mode
EXT_LOOP: COM1 defaults to external loopback mode
FORMAT=<format>—Sets or displays the COM1 port data characters, parity, and stop bits setting. Valid data parameters are:
7N1 —seven char bits, no parity, one stop bit
7N2 —seven char bits, no parity, two stop bits
7O1 —seven char bits, odd parity, one stop bit
7O2 — seven char bits, odd parity, two stop bits 7E1 —seven char bits, even parity, one stop bit
7E2 —seven char bits, even parity, two stop bits
8N1 —eight char bits, no parity, one stop bit (default setting)
8N1 —eight char bits, no parity, two stop bits
4-6 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489