2 |
Observe the transceiver LEDs on the top cover for the proper indications. In a normally - operating system, the following LED indications should be seen within 30 seconds of
▪
▪
▪
▪
The table below details the LED functions for Remotes and AP radios.
LED Label | Activity | Indication |
LAN/ETH | ON | LAN or endpoint detected |
| Blinking | Data TX or RX |
| OFF | LAN or endpoint not detected |
COM1 | Blinking | Data TX or RX |
(MGT System) | OFF | No data activity |
| ||
COM2 | Blinking | Data TX or RX |
| OFF | No data activity |
PWR | ON | Primary power (DC) present |
| Blinking | Radio in “Alarmed” state |
| OFF | Primary power (DC) absent |
LINK (AP) | ON | Lights when radio has finished its startup cycle. |
|
| Remains lit. |
LINK (Remote) | ON | Connected to an AP |
| OFF | Not connected to an AP |
Chapter 2 Tabletop Setup and Evaluation |