
8 |
Upgrade Procedure
To upgrade the transceiver firmware file (filename.gpk), use the procedure below.
1.Launch a TFTP server on a PC connected either directly or via a LAN to the transceiver Ethernet port (LAN). Configure the server to allow downloads from the directory containing the firmware image file.
2.Connect to the TS Wireless MS using a Web browser or Telnet session via the LAN, or Terminal emulator via the COM1 port, whichever is easier.
3.Go to the TS Wireless MS Reprogramming Menu.
(Main Menu>Maintenance Menu>Reprogramming Menu)
4.Fill in the information for the following:
▪TFTP Host
▪Retrieve
5.Pull the firmware file through the TFTP server into the TS Wireless radio.
(Main Menu>Maintenance Menu>Reprogramming Menu>Retrieve File)
▪Transfer status messages are displayed at the PC. You can cancel the transfer at any time by pressing CTRL C.
▪If the transfer does not start, verify that the AP and the PC can PING each other.
6.Restart the transceiver with the new firmware image to make it active.
Main Menu>Maintenance Menu>Reprogramming Menu>Reboot Device
7.Test the transceiver for normal operation. End of procedure.
Chapter 8 Technical Reference |