High End Systems Technobeam manual Safety Precautions

Safety Precautions

This section lists precautions you must follow anytime you are using the Laser Aiming Device™ (LAD™) for Technobeam.

1.CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

2.Using the Laser Aiming Device with any fixture other than Technobeam may result in damage to both the laser and the fixture as well as exposure to laser radiation.

3.Do not point the laser at an audience.

4.Precautions should be taken to ensure that the laser beam is not unintentionally directed at mirror-like (specular) surfaces (most importantly, at flat mirror-like surfaces).

5.Only qualified and trained employees approved by a laser safety officer should be assigned to install, adjust and operate the laser equipment.

6.When not in use, the laser (fixture) should be stored in a location where unauthorized personnel cannot gain access.

7.Do not remove the labels shown at the bottom of this page; they are required by U.S. and European safety agencies.

8.Areas in which this product is used should be posted with a standard laser warning sign.

9.Do not stare directly into the beam and do not view the beam with optical instruments.

10.The laser path should be located well above or below eye level.

11.The laser beam should be terminated at the end of its useful path.

12.Consult local and state laws regarding laser use and possible registration requirements.

DANGER

LASER RADIATION - AVOID

DIRECT EYE EXPOSURE

Max output: 5mW at 630-650 nm

CLASS 3a LASER PRODUCT

AVOID EXPOSURE

Laser radiation is emitted from this aperture Emission indicator

LASER RADIATION - DO NOT

STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS

Max output: 5mW at 630-650 nm CLASS 3a LASER PRODUCT Cert. to EN 60825-1, 1994

and 21 CFR 1040

Laser aiming device assembly (inside fixture)

5-2 Safety Precautions Technobeam® User Manual