High End Systems Technobeam manual

Figure 1-1.	Identifying yoke components	1-8
Figure 1-2.	Installing the yoke on the fixture	1-9
Figure 1-3.	Removing the door allows you to access the fixture’s voltage
selection switches, as well as wheels and optics		1-11

Figure 1-4. The three voltage selection switches located next to the LED display. 1-11

Figure 1-5.	Setting the fixture’s voltage and frequency	1-11
Figure 1-6.	The lens tube contains the zoom lenses	1-12

Figure 1-7. Squeeze the two latches on each side of the lens tube to open the cover. 1-12

Figure 1-8. Components of the factory-installed 11 to 17 degree lens set. 1-13Figure 2-1. The initial LED menu display shows the fixture’s software version..

2-2
Figure 2-2.	Location of the three status LEDs on the fixture’s access door...	2-3
Figure 2-3.	Properly-constructed data cabling	2-5
Figure 2-4.	Constructing a data cable terminator	2-6

Figure 2-5. Location of the DMX data in (male) and DMX data Out (female) ports

on the fixture’s rear panel 2-7

Figure 2-6. Connecting fixtures to a controller. Make sure you terminate the last

fixture in the link		2-8
Figure 2-7.	Use a locking washer when attaching a fixture to a truss	2-10
Figure 2-8.	Always use a safety cable when mounting the fixture	2-11

Figure 2-9. Location of the T-handle you use to adjust the yoke position. 2-11 Figure 2-10. You can slide the yoke all the way back to allow the fixture to hang

upside-down		2-12
Figure 2-11.	Menu navigation buttons	2-13
Figure 2-12.	This fixture has software version 3	2-19
Figure 2-13.	Location of the fixture’s exhaust vent	2-21
Figure 3-1.	Technobeam navigation buttons	3-2
Figure 4-1.	Making sure the shutter is open	4-5

Figure 4-2. A dot always appears in the LED display whenever preset playback

is on. ..................................................................................................... 4-9

Figure 4-3. When you set up fixtures for synchronized playback on a DMX 512 link, one and only one fixture must be fixture number 1 or DMX start channel 1.

The last fixture on the link must be terminated 4-10

Figure 5-1. The laser light exits the through the same aperture as the light beam. 5-4

Figure 5-2. The ideal position of the laser is no more than 2” (5 cm) directly

above the center point of a perfectly round light beam		5-4
Figure 5-3.	Removing the access door	5-6
Figure 5-4.	LAD wiring connections	5-7
Figure 5-5.	The laser aiming device circuit board	5-8
Figure 6-1. Removing the door allows you to access the fixture’s voltage
selection switches and fuses, as well as wheels and optics		6-3
Figure 6-2.	Locations of the three fuses on the circuit board	6-4
Figure 6-3.	Location of the wheels in Technobeam	6-5

i Ecodome User Manual