Table 3-1. Technobeam Menu Map
Menu | Menu | Menu | Menu | Menu | Description | |
Level 1 | Level 2 | Level 3 | Level 4 | Level 5 | ||
| ||||||
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
| FA01 - |
| select a scene to copy from (source scene) for | |
|
| FROM | FA16 |
| user A | |
|
| FB01- |
| select a scene to copy from (source scene) for | ||
|
|
|
| |||
| COPY |
| FB16 |
| user B | |
|
| TA01 - |
| select a scene to copy to (destination scene) | ||
|
|
|
| |||
|
| TO | TA16 |
| for user A | |
PRST |
| TB01 |
| select a scene to copy to (destination scene) | ||
|
|
| ||||
|
|
| TB16 |
| for user B | |
| CAPT | SN01 - |
|
| select a scene to capture a | |
| SN16 |
|
| scene to (from your DMX controller) | ||
|
|
|
| |||
|
|
|
|
| enable the | |
| DFLT | OK? |
|
| scene sequence - erases any preset scenes | |
|
|
|
|
| previously programmed |
Menu Options
The sections below explain how to access the individual menu options shown in the fixture’s menu map.
Address Menu (ADDR)
Use the Address menu to quickly change the current fixture number/ DMX start channel. Using this menu option, you can only change the existing fixture number to another fixture number, or the existing DMX start channel to another DMX start channel.
If you want to change the way you identify the fixture (i.e. change to a fixture number instead of a DMX start channel, or vice versa), complete the procedure described in “Changing the Control Method (CHNL)” on page
To change the current fixture number or DMX start channel:
1. Press and hold the <Menu> button until “ADDR” appears on the LED display.
2.Press the <Enter> button to select the “ADDR” menu.
| 3. Use the <Up> and <Down> arrow buttons to select a new DMX start | |
or | channel (C001 - C512) / fixture number (F 01 - F xx). The LED display | |
will flash when a new option is selected. | ||
|
4. Press the <Enter> button to accept the new fixture number / DMX start channel. The LED display will stop flashing when a new option is entered. If you do not press the <Enter> button, the new option you selected will not be stored.
Note | Be sure you do not overlap fixture channel ranges when |
| changing the fixture number/DMX start channel. |
| Technobeam® User Manual |
