High End Systems Technobeam manual Emission Indicator LED ON, Laser OFF, LAD wiring connections

2.Check all wiring connections shown in Figure 5-4:

LAD cables

Figure 5-4. LAD wiring connections.

3.Check to make sure the cable labeled “LAD” is connected to the main circuit board (with the LED display).

4.Replace the access door, plug the fixture in and make sure you have enabled the laser as shown in the section titled “Controlling the Laser” on page 5-5.

5.If the Emission Indicator LED and laser are both still OFF, contact High End Systems Customer Service in one of the ways shown in “Contacting High End Systems” on page Intro-4.

Emission Indicator LED ON, Laser OFF

1.The laser aiming device assembly is not receiving power. Check the connection at the laser aiming device circuit board, shown in Figure 5-5.

Technobeam® User Manual Troubleshooting 5-7