4.Only qualified and trained employees approved by a laser safety officer should be assigned to install, adjust and operate the laser equipment.
5.When not in use, the laser (fixture) should be stored in a location where unauthorized personnel cannot gain access.
6.Do not stare directly into the beam and do not view the beam with optical instruments.
7.The laser path should be located well above or below eye level.
The section titled “Safety Precautions” on page
Live Components
You will be accessing live components and adjusting the laser in the next section. Take special care to avoid contacting
High voltage components are located in main circuit board
Figure 6-24. High-voltage component location.
When you activate the laser, observe the following precaution:
Caution | Do not stare into the beam or view it directly |
| with optical instruments. Avoid accidental |
| exposure to laser radiation. |
| Technobeam® User Manual |
