High End Systems Technobeam manual Table of Tables

Figure 6-26.		Locating the center point of the projected light beam. The
		laser should be no more than 2” (5 cm) above the center	6-24
Figure 6-27.		The laser aiming device assembly has three screws that can
		be used to adjust the position of the laser	6-25
Figure B-1.	Factory configuration of the Technobeam rotating litho wheel.		. B-1
Figure B-2.	Factory configuration of the Technobeam color wheel		B-2
Figure B-3.	Factory configuration of the Technobeam rotating effects
		wheel	B-2

Table of Tables

Table 1-1.	Optional Accessories	1-5
Table 1-2.	Beam Angles for Factory-Installed 11 to 17 Degree Lens Set	1-14
Table 1-3. Beam Angles for Optional 8 to 12 Degree Narrow Angle Lens
	Set	1-14
Table 2-1.	Status LEDs	2-3
Table 2-2.	Example: Determining the DMX Start Channel	2-16
Table 2-3.	Example: Determining the Unique Fixture Number	2-17
Table 2-4. Example of Wasted DMX Channels		2-18
Table 3-1. Technobeam Menu Map		3-3
Table 6-1.	Replacement Fuses	6-2
Table 6-2.	Fuse Failure Symptoms	6-3
Table A-1. Technobeam DMX Protocol		A-3
Table A-2. Technobeam-i DMX Protocol		A-8
Table A-3. MSpeed Movement Times		A-13
Table A-4. Macro DMX Channel Assignments		A-15
Table A-5.	Fixture Number to DMX Start Channel Conversion	A-16

Technobeam® User Manual xi