page
4.Make sure the fixture cannot be rotated all the way around (360o). Allowing the fixture to rotate 360o could loosen the clamp mounting bolts.
Note | Because of the variety of conceivable lighting designs, |
| you should consider the procedure below as a suggested |
| guideline only. High End Systems, Inc. cannot make |
| specific recommendations for your particular lighting |
| design or venue. |
Suggested mounting procedure:
1.Use two people to mount each fixture: one person to hold the fixture while it is being secured in place, and one person to secure the fixture to its support and to attach clamps and safety cables.
2.Always stand on a firm, stable surface when mounting a fixture to its support. The fixture should be at a height where you can comfortably work on it, and should either be resting on a stable surface or held in a stable manner. Do not allow one person to both support and mount the fixture.
3.Attach a suitable clamp through one of the holes on top of the yoke. If you are attaching one clamp, use the middle hole on the yoke. If you are attaching 2 clamps per fixture, attach one clamp to each of the outer holes on the yoke. Use two locking washers per clamp when attaching the clamp to the yoke.
Truss
Clamp securely on truss
Use two (2) locking washers
Insert bolt through hole in top of yoke
Figure 2-7. Use a locking washer when attaching a fixture to a truss.
| Technobeam® User Manual |
