
2.Press the <Enter> button to enter the “ADDR” menu.
3.Using the <Up> and <Down> arrow buttons, scroll to the desired DMX
t | start channel and press the <Enter> button to select the desired DMX | |
start channel. |
| |
| Note | You must assign a unique fixture address to each Studio |
|
| Spot 250 or Studio Color 250 fixture that you wish to |
|
| respond independently to controller commands. |
Determining the Unique Fixture Number
The fixture number is a number you assign that represents each unique fixture’s channel range in the DMX 512 link. If you are using one DMX link to control fixtures which all use the same number of DMX channels (as recommended), you can assign fixture numbers in ascending order (see Table
Table
Fixture |
| Number of DMX | Fixture | Channel | |
location | Fixture name | channels used | |||
number | range used | ||||
on the link |
| per fixture | |||
|
|
| |||
|
|
|
|
| |
|
|
|
|
| |
First | Technobeam | 18 channels | F 01 | ||
(iris protocol) | |||||
|
|
|
| ||
Second | Technobeam | 18 channels | F 02 | ||
(iris protocol) | |||||
|
|
|
| ||
Third | Technobeam | 18 channels | F 03 | ||
(full protocol) | |||||
|
|
|
| ||
Fourth | Other device | 18 channels | F 04 | ||
(using 18 channels) | |||||
|
|
|
|
t
To assign a unique fixture number to your fixture:
1. Press and hold the <Menu> button until “ADDR” appears on the LED display.
2.Press the <Enter> button to enter the “ADDR” menu.
3. Using the <Up> and <Down> arrow buttons, scroll to the desired fixture number and press the <Enter> button.
Note | You must assign a unique fixture address to each |
| Technobeam fixture that you wish to respond |
| independently to controller commands. |
Wasted DMX Channels
If you mix different types of devices (which use different numbers of channel ranges) on the same DMX link and assign fixture numbers (instead of DMX start channels) to these devices, you would waste DMX channels.
Technobeam® User Manual | Configuring the Fixture |