High End Systems Technobeam manual Powering On the Fixture, Homing the Fixture, LED Display

Powering On the Fixture

Do all of the following before powering on the fixture:

1.Select the correct voltage and frequency settings for the power outlet you will be using. See the section titled “Setting the Fixture Voltage” on page 1-10.

2.Install the appropriate power cord cap as described in the section titled “Installing the Power Cord Cap” on page 1-7.

3.Replace the access door shown in Figure 2-2 on page 2-3.

Homing the Fixture

Connect the fixture to an appropriately-rated power outlet; there is no power switch. You will hear the sounds of the motors and gears as they home. This is normal.

LED Display

When the fixture has finished homing, the LED display should show the fixture’s software version, similar to Figure 2-1:

R

MENU ENTER

Figure 2-1. The initial LED menu display shows the fixture’s software version.

Note	The LED display will alternate between the version
	number (shown above) and the fixture number or DMX
	start channel unless an error occurs during start-up.

If the fixture fails to home, or if the menu displays an error message, see the section titled “Troubleshooting” on page 2-20 now.

2-2 Powering On the Fixture Technobeam® User Manual