•TR F (Technoray full protocol) - for use with Technoray fixtures only. This protocol uses 14 channels and is recommended, unless you need to conserve the extra two DMX channels for other devices on the link. The full protocol gives you more control over the rotating litho wheel position and litho spin speed and allows you to access the macros.
•TR R (Technoray reduced protocol) - for use with Technoray fixtures only. This protocol uses 12 DMX channels.
•TPRO (Technopro protocol) - for use with Technopro fixtures only. This protocol uses 12 DMX channels.
•TB I
•TLCD (Technopro LCD protocol) - for use with Technopro fixtures controlled with an LCD controller. This protocol uses 18 DMX channels and allows you to access the macros.
To set the fixture type and protocol:
1. Press and hold the <Menu> button until “ADDR” appears on the LED display.
2.Using the <Up> and <Down> arrow buttons, scroll to the “MODE” menu
and press the <Enter> button to select the “MODE” menu.
3. Using the <Up> and <Down> arrow buttons, scroll to the “TYPE” menu. (This will be the first menu displayed). Press the <Enter> button to select the “TYPE” menu.
4.Using the <Up> and <Down> arrow buttons, choose the desired option (listed above) and press the <Enter> button to select the desired option.*
*Note | This option has a |
| changes. To change the fixture type, you must press and |
| hold the <Enter> button for at least 5 seconds. |
Setting the User Type (USER)
Use this menu item to change the fixture’s user type from user A to user B or vice versa. Each user type includes 16 different presets (scenes) and the following fixture settings:
•Fixture Address
•Pan Invert
•Tilt Invert
•Pan/Tilt Swap
•Control Method (addressing via fixture number or DMX start channel)
•Display Settings (On, Off, or Dim)
| Technobeam® User Manual |
