High End Systems Technobeam manual Status LEDs

Status LEDs

Technobeam fixtures have three status LEDs located on the access door, as shown in Figure 2-2:

Door retaining screw

Access door

Figure 2-2. Location of the three status LEDs on the fixture’s access door.

Table 2-1 describes the three status LEDs:

Table 2-1. Status LEDs

LED name	State	Problem	Description
		Indication?
Motor	solid red	No	The motors are receiving adequate
			voltage.
	OFF	Yes	Fuse or power failure. See below.
Transmit	OFF	Not necessarily*	No data is being transmitted.
	flickering yellow	No	A software crossload is taking place.
	solid yellow	Yes†	Software or hardware failure.
Receive	OFF	Not necessarily*	No data is being received.
	flickering green	No	Fixture is receiving data.

If the LED states indicate a problem, see the section titled “Troubleshooting” on page 2-20.

*- The Receive LED will not be ON unless the fixture is connected to a DMX 512 link with a working controller. If you have already connected

Technobeam® User Manual Powering On the Fixture 2-3