High End Systems Technobeam manual Setting the Fixture Voltage

Door retaining screw

Access door

Figure 1-3. Removing the door allows you to access the fixture’s voltage selection switches, as well as wheels and optics.

3.Locate the three switch blocks—labeled SW1, SW2 and SW3—by the LED display, as shown in Figure 1-4:

Figure 1-4. The three voltage selection switches located next to the LED display.

4.Choose a voltage/frequency setting as shown in Figure 1-5:

Top of fixture

Figure 1-5. Setting the fixture’s voltage and frequency.

5.Replace the access door, unless you want to install the optional narrow lens set or set the beam angle as shown in the next section.

Technobeam® User Manual Setting the Fixture Voltage 1-11