oThis keyword is to enable the use of batching receives within a specific time period.
oMin = 0, disabled
oMax = 5000000, 5 seconds
oUnits are in micro seconds
oDefault = 360
•TxPacketsPer=
oThis keyword is to enable the use of batching transmits to a specific amount of packets.
oMin = 0, disabled
oMax = 100
oDefault = 64
•CheckSum=
oThis keyword is to enable or disable the transmit & receive checksum off loading feature. The checksum off loading support is only for TCP/IP packets. For that reason, the default OFF.
oChoices are: ON, OFF, TX, RX
oDefault is ON
•TxFlow=
oThis keyword allows enabling/disabling of TxFlow control.
oChoices are: ON, OFF
oDefault is OFF
•RxFlow=
oThis keyword allows enabling/disabling of RxFlow control.
oChoices are: ON, OFF
oDefault value is OFF
•VLAN=
oThis keyword allows enabling/disabling of VLAN tagging support. This keyword is only used when the QASP program is loaded for VLAN support on the Q57 driver. Do not set the VLAN keyword to 1 if the QASP program is not being used.
oChoices are: 0 (Disabled), 1 (Enabled)
oDefault value is 0
•Jumbo=
oThis keyword enables Jumbo frame support. When enabled, jumbo packets of up to 9000 bytes are supported.
o
oDefault is jumbo packets not supported.
•PDriver=
oThis keyword allows for the driver to operate in persistent driver mode. Only use it if the adapter is placed in a Hot Plug PCI slot and only if required to swap with an exact same board.
oChoices are: ON, OFF
oDefault value is OFF
