HP 441877-00B manual Team properties

3.Select two to eight of the listed adapters by single-clicking them. Individual stand-alone adapters will

remain selected as you click them. After you have selected all the desired adapters for a team, click the Team button on the upper-right of the main dialog window.

IMPORTANT: If the proper Service Pack level (SP5) has not been installed on the system, a popup message displays warning you of this condition. If this message is displayed, install the correct Service Pack before proceeding.

4.The Teaming Property Sheet appears for the newly created team. The first page displayed is the

Teaming Controls Sheet. The default mode of operation for a team is Fault Tolerant mode. Change this to the desired mode of operation by selecting either Fault Tolerant or Load Balancing at the top of the page.

5.For a Fault Tolerant team, select among the following modes:

Manual. Causes a failover when the user clicks Switch Now. In this mode, a failover will also occur if the Current Primary adapter is dropped from the team. Recommended only for troubleshooting purposes.

Fail on Fault (Default). If a failover event occurs, a non-Primary adapter takes on the role of the Current Primary adapter. This new Current Primary adapter remains primary unless another failover event occurs, or the system is rebooted.

Smart Switch. If a failover event occurs, a non-Primary adapter takes on the role of Current Primary adapter. This new Current Primary adapter remains primary until one of the following occurs. The Preferred Primary adapter becomes available, and a failback occurs, in which case the Preferred Primary adapter resumes its role as Current Primary adapter. Or, another failover event occurs, in which case, a non-Primary adapter takes on the role of Current Primary adapter. If this mode is selected, make sure the desired Primary adapter is displayed in the Preferred Primary NIC list box. A single Fault Tolerant team CAN contain a mixture of Fast Ethernet and Gigabit adapters.

6.For a Load Balancing team, select among the following modes: o Transmit Load Balancing

o Switch-assisted Load Balancing

7.Select the Settings tab at the top of the Teaming Property Sheet. On the Settings tab, you may configure the following items:

Team Network Address. Used to "Locally Administer" the team's unique receive node address on the network like you would locally administer a single adapter's node address.

Enable Heartbeats. This check box is used to enable/disable teaming Heartbeats. Heartbeats provide an additional level of adapter failure detection above simple link failure detection. Heartbeat detection, if enabled, will cause Heartbeat packets to be transmitted between the Primary adapter and Secondary adapters to ensure proper transmit and receive functionality among the adapters in the team.

Heartbeat timer interval. This value specifies the amount of time to wait before transmitting Heartbeat packets between adapters in the team. Heartbeats are not transmitted between the adapters if normal network transmit/receive traffic is passing through the adapters. However, in the absence of network traffic, after the specified Heartbeat timeout period expires (the timer interval value), Heartbeat packets are sent. This value MUST be greater than 3000 ms (3 seconds).

8.Click OK on the Teaming Property Sheet dialog to complete the configuration of the team.

9.Repeat Steps 3–8 to create additional teams as desired.

10.Click Close at the bottom of the Main CPQNTAC dialog to finish configuration of teams.

Team properties 138