recommended selection is Auto and it is the default setting. To disable Flow Control, select Disable from the Value list on the Advanced tab.

oAuto. (Default) Auto detect flow control

oDisable. PAUSE frame receipt and transmission is disabled

oTx PAUSE. PAUSE frame transmission is enabled

oRx PAUSE. PAUSE frame receipt is enabled

oRx/Tx PAUSE. PAUSE frame receipt and transmission is enabled

•Speed & Duplex. The Speed & Duplex parameter allows the user to set the connection speed to the network and mode. The Duplex Mode allows the adapter to transmit and receive network data simultaneously. The adapter is set to Auto (optimum connection) by default. Set the speed and mode as described below:

o10 Mb Full. Sets the speed to 10 Mbps and mode to Full-Duplex

o10 Mb Half. Sets the speed to 10 Mbps and mode to Half-Duplex

o100 Mb Full. Sets the speed to 100 Mbps and mode to Full-Duplex

o100 Mb Half. Sets the speed to 100 Mbps and mode to Half-Duplex

oAuto. (Default) Sets the speed and mode for optimum network connection (recommended)

NOTE: 1 Gbps speed is enabled by selecting Auto.

NOTE: Auto is the recommended selection. It allows the adapter to dynamically detect the line speed and duplex mode of the network. Whenever the network capability changes, the adapter will automatically detect and adjust to the new line speed and duplex mode.

The Half-Duplex selection forces the adapter to connect to the network in Half-Duplex mode. The adapter may not function if the network is not configured to operate at the same mode.

The Full-Duplex selection forces the adapter to connect to the network in Full-Duplex mode. The adapter may not function if the network is not configured to operate at the same mode.

•Wake Up Capabilities. The Wake Up Capabilities parameter allows the user to set the adapter to wake up from a low power mode when it receives a network wake up frame. Two wake up frames are possible: Magic Packet and Wake Up Frame. By default, the adapter is set to Both. To choose the type of frame that will cause the adapter to wake up, select the appropriate option from the Value drop-down list on the Advanced tab.

o Both. (Default) Selects both Magic Packet and Wake up Frame as wake up frames o Magic Packet. Selects Magic Packet as the wake up frame

o None. Selects no wake up frames

o Wake Up Frame. Selects Wake up Frame as the wake up frame

NOTE: This property is not supported by NC150T adapters.

•WOL Speed. The WOL Speed parameter allows the user to select the speed at which the adapter connects to the network while in Wake-on-LAN mode. By default, the adapter is set to Auto.

o 10 Mb. Sets the speed to 10 Mb

o 100 Mb. Sets the speed to 100 Mb

Adapter configurations 102