Parameter | Options | Description |
|
|
|
|
|
PDriver = | Default = OFF | Allows driver to operate in persistent driver |
|
| Selections are: OFF, ON | mode. Persistent driver mode is supported |
|
| under NetWare 5.x only. Use only if adapter |
| |
|
|
| |
|
| is placed in a Hot Plug PCI slot and only if |
|
|
| required to swap with an exact board. |
|
|
|
|
|
RxBuffers = | Default = 200 |
| |
| Recommended Min = 32 | receiving packets |
|
|
|
| |
| Max = 512 |
|
|
| Min = 1 when used with DOS |
|
|
| Client32 and when Keywrod |
|
|
|
|
| |
|
|
|
|
TxDescriptors = | Default = 200 |
| |
| Recommended Min = 100 | transmitting packets. |
|
|
|
| |
| Max = 512 |
|
|
| Min = 1 when |
|
|
| used with DOS |
|
|
| Client32 and when |
|
|
| Keywrod |
|
|
| 2. |
|
|
RxFlow = | Default = OFF | Allows enabling/disabling of RxFlow control. |
|
| Selections are: ON, OFF |
|
|
|
|
|
|
TxFlow = | Default = OFF | Allows enabling/disabling of TxFlow control. |
|
| Selections are: ON, OFF |
|
|
|
|
|
|
Slot = n |
| Identifies the slot number for the specific |
|
|
| adapter currently being configured. This |
|
|
| parameter is not necessary if only a single |
|
|
| adapter is installed. |
|
|
|
|
|
Speed = n |
| If link negotiation has been disabled, specifies |
|
|
| port speed to be either Auto, 10HD or 10FD, |
|
|
| 100HD or 100FD. |
|
|
|
|
|
Jumbo = | Set maximum physical receive | Enables/disables Jumbo Frame support. When |
|
| packet Size = 18000 in the | enabled, jumbo packets of up to 9000 bytes |
|
| STARTUP.NCF. Choices are | are supported. Not supported on NC1020 |
|
| Jumbo = | adapters. |
|
| keyword is only supported on |
|
|
| NetWare 6.x. |
|
|
|
|
|
|
Link= | Default=FORCE | Only used to allow the adapter to negotiate a |
|
| Selections are: AUTO, FORCE | specific or forced line speed with a switch that |
|
|
| is not forced, but instead setup for auto- |
|
|
| negotiation. It is best to allow for auto- |
|
|
| negotiation of the card and switch by not |
|
|
| setting this keyword or the speed keyword. |
|
|
| Only use this keyword if the speed keyword is |
|
|
| set to something other than AUTO. |
|
|
|
|
|
RxTicks= | Default = 360 | Enables the use of batching receives within a |
|
| Min = 0, disabled | specific time period. |
|
|
|
| |
| Max = 5000000, 5 seconds |
|
|
| Units are in micro seconds |
|
|
|
|
|
|
|
| Installation 30 |