b.If prompted to restart your computer, click Yes. Rebooting the system for new adapter properties to take effect is not required; however, rebooting is recommended to re-initialize all registers.

Windows Server 2003 and Windows Server 2003 x64 adapter properties

•802.1p QoS Packet Tagging. The 802.1p QoS parameter is a standard that enables Quality of Service. This property is disabled by default. To change this property, select Enable or Disable.

•Checksum Offload. Normally the Checksum Offload function is computed by the protocol stack. By selecting one of the Checksum Offload properties, the checksum can be computed by the Gigabit Ethernet Adapter.

To enable one of the Checksum Offload properties select the property from the Value list on the Advanced tab.

o None. Disables checksum offloading

o Rx TCP/IP Checksum. Enables receive TCP, IP, and UDP checksum offloading o Tx TCP/IP Checksum. Enables transmit TCP, IP, and UDP checksum offloading

o Tx/Rx TCP/IP Checksum. (Default) Enables transmit and receive TCP, IP, and UDP checksum offloading

•Ethernet@WireSpeed. This property is only available through the HP Network Configuration Utility. The Ethernet@WireSpeed property enables a 1000Base-T Ethernet adapter to establish a link at a

lower speed when only two pairs of wires are available in the cable plant. By default, this property is enabled. To disable the Ethernet @ WireSpeed property, select Disable from the Value list.

o Disable. Disables Ethernet@WireSpeed

o Enable. (Default) Enables Ethernet@WireSpeed

•Flow Control. The Flow Control property allows the user to enable or disable the receipt or transmission of PAUSE frames. PAUSE frames enable the adapter and the switch to control the transmit rate. The side that is receiving the PAUSE frame will momentarily stop transmitting. The recommended selection is Auto and it is the default setting. To disable Flow Control, select Disable from the Value list on the Advanced tab.

o Auto. (Default) Auto detect flow control

o Disable. PAUSE frame receipt and transmission is disabled o Tx PAUSE. PAUSE frame transmission is enabled

o Rx PAUSE. PAUSE frame receipt is enabled

o Rx/Tx PAUSE. PAUSE frame receipt and transmission is enabled

•Large Send Offload. Normally, the TCP segmentation is performed by the protocol stack. By enabling the Large Send Offload property, the TCP segmentation can be performed by the Gigabit Ethernet Adapter. To enable the Large Send Offload property, select Enable from the Value drop- down menu on the Advanced tab.

o Disable. Disables large send offloading o Enable. Enables large send offloading

•Locally Administered Address. Specifies the user-defined MAC Address of the adapter, which overrides the burned-in MAC Address. This box is disabled if the selected adapter has been teamed.

o Default = Not Present

o Range = Value; Not Present

Adapter configurations 99