5.Read only bit %s got changed after writing 1's at offset 0x%X
6.Read/Write bit %s did not get cleared after writing zero at offset 0x%X
7.Read/Write bit %s did not get set after writing 1's at offset 0x%X
8.BIST failed.
9.Could not generate interrupt
10.Test aborted by user
11.Tx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
12.Rx DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
13.Tx DMA failed
14.Rx DMA failed
15.Data error, got 0x%08X at 0x%08X, expected 0x%08X
16.Second read error, got 0x%08X at 0x%08X, expected 0x%08X
17.Failed writing EEPROM at 0x%04X
18.Failed reading EEPROM at 0x%04X
19.EEPROM data error, got 0x08X at 0x04X, expected 0x%08X
20.Cannot open file %s
21.Invalid CPU image file %s
22.Invalid CPU image size %d
23.Cannot allocate memory
24.Cannot reset CPU
25.Cannot release CPU
26.CPU test failed
27.Invalid Test Address Range
Valid adapter address is
28.DMA:Got 0x%08x @ 0x%08x. Expected 0x%08x
29.Unsupported PhyId %04X:%04X
30.Too many registers specified in the file, max is %d
31.Cannot write to VPD memory
32.VPD data error, got %08X @ 0x04X, expected %08X
33.No good link! Check Loopback plug
34.Cannot TX Packet!
35.Requested to Tx %d. Only %d is transmitted
36.Expected %d packets. Only %d good packets are received %d unknown packets have been received
%d bad packets have been received
37.%c%d is an invalid Test
38.EEPROM checksum error
39.Error in reading WOL/PXE
40.Error in writing WOL/PXE
