
RxPause
TxPause
RxPause/TxPause
NOTE: 1000 Mbps (1 Gbps)
NOTE:
NOTE: A kernel relink and reboot is required before the new configuration will take effect.
For more detailed information and tuning parameters, at the command prompt enter:
man bcme
Jumbo Frames and other advanced parameters
Jumbo MTU sizes and other advanced, tunable parameters for the controller are located in the file space.c in the directory /etc/conf/pack.d/bcme. A description for each parameter is contained in space.c. Modify the desired parameter in space.c, rebuild the kernel, and reboot the system. The MTU sizes can be individually set for each adapter in the system (Jumbo Frames is not supported on the NC1020). All other parameters apply globally to all adapters.
UnixWare 7.x and OpenServer 6.x
The following procedure describes the installation of the UnixWare driver. The driver is released as a PKG file.
Installing the driver locally
1.Copy the file
2.Enter the following command: pkgadd
Creating a diskette
1.Copy the file
2.Create a diskette using the following command: dd
Installing the driver from a diskette
1.Use pkgadd
2.Use netcfg or scoadmin network to add the new network adapter.
3.When prompted, select the Line Speed and then select Advanced Option for Flow Control, MAC Address, and Jumbo MTU Size settings, if desired. The settings for these parameters are listed below:
oLine Speed
Auto Negotiation (default) 10 Mbps
10 Mbps
100 Mbps