•
•
•
•
•
•
Examples of IBAUtil command lines
The following are examples of some typical IBAUtil command lines.
•Disables WOL on all HP network adapters:
IBAUTIL
•Enables WOL on the second HP network adapter found in your system:
IBAUTIL
•Updates the Boot Agent image on all HP network adapters:
IBAUTIL
•Enables the Boot ROM on the first HP Network Adapter found in your system:
IBAUTIL
Boot Agent messages
The following error and information messages may be displayed during initialization. Possible causes and how to avoid an error condition are provided where applicable.
•Flash device wrong size
This error message can occur when using IBAUtil. The full version of Boot Agent software cannot be loaded into a flash ROM device smaller than 64 KB. If a 32 KB (or smaller) flash ROM device is detected in the adapter, the flash update software returns this message. Assuming the device is socketed, remove the "too small" device and install a blank 64 KB (or larger) flash ROM device.
•Invalid PMM function number
PMM is not installed or is not working correctly. Try updating the BIOS.
•PMM allocation error
PMM could not or did not allocate the requested amount of memory for driver usage.
•Press Ctrl+S to enter the Setup Menu.
Instructs you how to enter the configuration setup menu.
•
System does not have enough free memory to run PXE image. The Boot Agent was unable to find enough free base memory (below 640K) to install the PXE client software. The system cannot boot via PXE in its current configuration. The error returns control to the BIOS and the system does not attempt to remote boot. If this error persists, try updating your system's BIOS to the
•
Image vendor and device ID do not match those located on the card. Be sure the correct flash image is installed on the adapter.
•
Adapter configurations 75