
o
o
NOTE: The HP NC31xx, 340T, and NC71xx Server Adapters support
NOTE: The NC3133 default to
NOTE: To set the adapter to half- or
oSyntax: FORCEDUPLEX=n Where n =
oDefault =
oExamples:
100 Mbps
10 Mbps
•SLOT. (Required) For PCI adapters, SLOT is derived from bus number and device location as defined by the PCI specification. One way to determine the slot number is to load the driver from the command line. You will be prompted with valid device number(s) for the adapter(s). Select one of them.
oSyntax: SLOT=n
Where n = 1, 2, 3, 4,...
•SPEED. This keyword specifies the speed the driver uses. If you do not use this parameter, the driver automatically detects the network speed. If unable to detect, the driver defaults to 10 Mbps. If you use this parameter, the driver operates at the specified speed instead of auto detecting network speed.
NOTE: The NC3133 adapter supports 100 Mbps only. It does not default to 10 Mbps. You must set the SPEED parameter to either 10 or 100 if you want to set the FORCEDUPLEX parameter to either half or full. The SPEED parameter is for N100.LAN, N1000.LAN, and N1000e.LAN drivers. You cannot change the speed for the Gigabit (fiber) adapters. You can, however, change the speed for the NC7170, NC7131, and NC7132 Gigabit (copper) adapters to 10 Mbps or 100 Mbps.
oSyntax: SPEED=n
Where n = 10 or 100 or 1000
oDefault = The adapter automatically detects network speed.