IBM 704 manual Installing a Microprocessor

Installing a Microprocessor

An example microprocessor/heat-sink assembly might contain the following components:

	1
	2
8	3
7	4
	5
	6

.1/ Heat sink retention clips (two)

.2/ Heat sink

.3/ Thermal grease

.4/ Microprocessor

.5/ Pin 1 location

.6/ Lower processor socket, with lever (latch) in open position

.7/ Upper processor socket, empty, with lever in closed, locked position

.8/ Completed microprocessor/heat-sink assembly

You will work with these components while performing the steps in this section.

If you want to add a second microprocessor to a processor board, you must first remove that processor board from its connector on the system board. To install a microprocessor, do the following steps:

1.Before you can access the boards inside the server, you must remove the metal board-support panel that holds them in place.

Chapter 4. Installing Options 89