Diskette Drive Problems Action, Monitor Self-Tests Action

Diskette Drive Problems

Diskette drive In-Use light stays on, or the system bypasses the diskette drive.

If there is a diskette in the drive, verify that:

1.The diskette is good and not damaged. (Try another diskette if you have one.)

2.The diskette is inserted correctly (label up and metal-shutter end first) in the drive.

3.The diskette contains the necessary files to start the system.

4.The system is not in Secure mode.

5.The diskette drive is enabled (check the drive startup sequence setting in the Setup program).

6.Your software program is OK (see the Software Problems troubleshooting chart provided later in this section).

7.Your drive startup sequence is set correctly (check the Boot Sequence setting in the Setup program).

If the diskette drive In-Use light stays on, or the system continues to bypass the diskette drive, have the system serviced.

Monitor Self-Tests	Action
	Some IBM monitors have their own self-tests. If you
	suspect a problem with your monitor, refer to the
	information that comes with the monitor for adjusting
	and testing instructions.
	If you still cannot find the problem, have the monitor
	and system serviced.