Installing the Top Cover

Completing the Installation

To complete your installation, you must reinstall the top and side covers, and reconnect all the cables that you disconnected in “Preparing to Install Options” on page 78. Follow the instructions in this section.

Installing the Top Cover

Before you begin:

Be sure you have:

ŸRead “Electrical Safety” on page 75 and “Handling Static-Sensitive Devices” on page 77 (or your safety booklet).

ŸTurned off peripheral devices (see “Preparing to Install Options” on page 78).

12 Attention: Do not damage or displace the electromagnetic interference (EMI) gaskets mounted on the cover. Replace any damaged gaskets, or your server might not meet EMI requirements.

To install the server top cover, do the following steps:

1.Before installing a side cover, make sure that you have not left loose tools or parts inside the server. Check that all cables, adapters, and other components are installed and seated correctly.

2.Lower the cover with the front edge about one inch back from the bezel edge. The leading corners of the cover should be outside the chassis metal.

3.Pull the cover toward the back slightly to make sure that it is aligned correctly.

Chapter 4. Installing Options 201

Page 219
Image 219
IBM 704 manual Completing the Installation, Installing the Top Cover