IBM 704 manual Installing Your Software

To install OS/2 LAN Server 4.0, do the following steps:

1.Run the MPTS utility program with LAN Server 4.0 or OS/2 Requester 4.0.

Note:

ŸMPTS = Multiple Protocol Transport Services

ŸLAPS = LAN Adapter Protocol Support

2.Click Install.

3.When you are prompted, insert the network-adapter configuration diskette in drive A and click OK.

4.When Install reads the network adapter disk, installation is complete. Click OK. The adapter driver has been copied to your server.

5.Click Configure from the MPTS window.

6.At the Configure window, make sure the LAN adapters and protocols button is highlighted, and click CONFIGURE.

7.At the LAPS Configuration window, select the appropriate network adapter from the Network Adapters windows.

8.Click Add in the Network Adapter window to add the network adapter to the current configuration.

9.Select your desired Protocols from the Protocol window. Click Add from this window to add the protocols to the current configuration.

10.Click OK when you are done and follow the prompts to exit MPTS. Your CONFIG.SYS file is automatically updated.

11.Shutdown and reset your server so that the changes you have made can take affect.

After you install OS/2 LAN Server 4.0, install the Fixpaks that were described at the beginning of this section; then, review “Device Drivers” on page 36 and “Installation Checklist” on page 37.

Chapter 2. Installing Your Software 33