Removing Internal Drives

b.Remove the carrier from on top of the drive.

c.Place the drive in a static-protective bag and store it in a safe place.

DevicesStatic

d.If you are installing another drive in the carrier, go to step 4 on page 175. Otherwise, continue with the next step.

8.Push the plastic lever to the right until it locks around the small metal posts.

9.Close the EMI metal panel and secure it with the three thumbscrews.

10.To restrict access to the bays, insert and lock a padlock through the holes at the left edge of the EMI panel.

11.If your server has a RAID adapter installed, refer to the RAID adapter documentation for details about configuration requirements. Record the RAID configuration information in the appropriate tables in “Installed Device Records” on page 280.

12.If you are removing another hot-swap drive, return to step 1 on page 190.

13.If you are installing another hot-swap drive assembly, slide the drive assembly vertically into the target bay until the drive connects to the backplane, and move the lever to the locked position.

14.If you are replacing an empty drive carrier in the bay, slide the drive carrier into the target bay until it is approximately level with the front of the bay; then, push the plastic lever to the right until it locks around the small metal posts.

Chapter 4. Installing Options 191

Page 209
Image 209
IBM 704 manual DevicesStatic