IBM 704 manual Removing Internal Drives

Removing Internal Drives

3.Remove the panel frame:

a.Press the two panel frame release tabs, located between the front edge of the cardcage and the metal flange (the tab locations are pinpointed but not shown at .1/ in the following figure).

b.Swing the frame out to the right; then, remove it from the chassis by disengaging the hinge tabs at the right edge of the frame (at .2/ in the following figure).

1

2

c.Place the filler panel frame face down on a soft surface to prevent marring the front of the frame unit.

4.Press the ends of the snap-in slide rails toward the drive until they release the bay guide rails.

5.Slide the drive out the front of the bay, and place it on a static-protective surface.

6.Remove the two screws that hold the grounding clip and each of the plastic snap-in slide rails to the side of the drive.

Chapter 4. Installing Options 183