IBM 704 manual Installing Internal Drives

Installing Internal Drives

9.Install the hard disk drive in the hot-swap bay:

a.Align the drive/carrier assembly vertically so that it engages the guide rails in the bay.

b.Gently push the drive assembly into the bay until the drive connects to the backplane.

c.Push the plastic lever to the right until it locks around the small metal posts.

10.Close the EMI metal panel and secure it with the three thumbscrews.

11.To restrict access to the bays, insert and lock a padlock through the holes at the left edge of the EMI panel.

12.Check the hard disk drive status indicators to verify that the hard disk drives are operating properly. See “Identifying Problems through Status Indicators” on page 258 for details.

13.If your server has a RAID adapter installed, refer to the RAID adapter documentation for details about configuration requirements. Record the RAID configuration information in the appropriate tables in “Installed Device Records” on page 280.

Chapter 4. Installing Options 177