IBM 704 manual Using the Module Tests

Starting the Test Programs

Using the Module Tests

To start the Module Tests from the Main Menu of the Diagnostic Diskette:

1.Start the diagnostic programs. If you do not know how to do this, see “Starting the Test Programs” on page 225.

2.Select Diagnostic from the Main Menu; then, press Enter.

3.Select Module Tests, then press Enter. Use the Up Arrow (↑) or Down Arrow (↓) key to move the highlight bar from one selection to the next within the Module Tests menu.

4.To select or deselect a test, use the Spacebar (the Spacebar toggles your selection on or off). When you have selected a test, a ♦ appears next to the selection.

5.If you want to run all of the selected tests, you can do so by moving the highlight bar to the last choice, Run All Selected Modules, then pressing Enter. If you want to run each test, one at a time, press Enter at the highlight bar of the desired selection.

Note: An asterisk (*) directly adjacent to an item indicates that running that test might damage your data. Make sure to back up all of your data before running the tests.

6.When you are done, press Esc to return to the Test Group window.

Note: As you move the highlight bar up or down the selection menu, the Test Group window to the right changes to correspond to the highlighted module.

Chapter 5. Solving Problems 227