IBM 704 manual Cmos system options have not been set

POST Error Messages

POST Message	Description
0195	The CMOS system options have not been set.
	Action:
	Ÿ If you have just replaced the real-time clock on the
	system board, start the Setup program to set the
	correct date and time. If the problem recurs, have
	the system serviced.
	Ÿ If you have not just removed or replaced the
	real-time clock, have the system serviced.
0198	The CMOS checksum is invalid.
	Action: Have the system serviced.
0289	A change in the memory configuration occurred. Installing
	memory incorrectly, such as not installing memory modules
	in matched sets, can cause this problem. It can also occur if a
	memory module is defective.
	Action: Ensure that the memory modules are installed
	properly (see “Installing Memory-Module Kits” on
	page 113). If the modules are properly installed, run
	the test programs to determine the cause of the
	problem and the action to take. If the test programs do
	not find the problem, have the system serviced.
0295	Address Line Short Detected.
	Action: Have the system serviced.
0297	The memory size has decreased.
	Action:
	Ÿ If you have just removed memory from the server,
	start the System Configuration Utility. Save the
	new configuration information; then, restart the
	server. If the problem recurs, have the server
	serviced.
	Ÿ If you have not just removed memory, have the
	server serviced.
0299	ECC Error Correction failed.
	Action: Turn off the system and wait 30 seconds; then, turn it
	back on. If event logging is enabled, POST logs this

event in nonvolatile flash memory. If the problem recurs, have the system serviced.

236PC Server 704 User's Handbook