IBM 704 manual Removing a Microprocessor

Removing a Microprocessor

6.Remove the two clips that hold the heat sink and microprocessor in place:

Note: When you remove the clips, avoid scraping them against the system-board components.

a.Insert a small, flat-blade screwdriver into the slot on the end of one clip.

b.Release the clip by pushing the clip outward with the blade of the screwdriver.

c.While moving the clip off the socket, slide the clip up and away from the heat sink and microprocessor.

d.Repeat steps 6a through 6c for the other clip.

e.After you remove these two clips, the heat sink will slide off.

7.Press the microprocessor socket lever down slightly and outward until it pulls up freely. Lift the lever until it stands straight up.

8.Grip opposite sides of the microprocessor and lift it out, without touching or bending the pins.

9.Wrap the microprocessor in conductive foam and store it in a static-protective bag.

10.Press the microprocessor socket lever down until it snaps into the locked position.

Chapter 4. Installing Options 107