IBM 704 manual Installing a Microprocessor

Installing a Microprocessor

could damage the processor board or the connector on the system board.

20.Reinstall the board-support panel:

a.Align the support panel so that the three tabs .1/ at the back left edge of the panel fit into the three chassis slots.

b.Close the panel. Check to make sure that the boards in the slots behind the panel align with the scribe marks on the panel. Use the scribe marks at .2/ to check the alignment of the memory board. Use the scribe marks at .3/ to check the alignment of the processor boards.

1

2

3

c.Secure the panel with the four screws that you removed in step 1b on page 90.

d.Reinstall the exterior side panel.

100PC Server 704 User's Handbook