About the Test Programs

Using the Command Line Options

The following Command Line Options allow you to define specific conditions for running the diagnostic programs at startup time.

At the operating system prompt, type QAPRO /XXX (where /XXX represents one of the following from the list below); then, press

Enter:

/B&WThe /B&W option forces the program to load in black and white (monochrome) mode.

/LOG=file

The /LOG=file option directs the test programs

 

to start using a specified Error Log file.

/INT10

The /INT10 option forces the test programs to

 

use the Basic Input/Output System (BIOS) for

 

screen writes.

/OXXX

The /OXXX option, where XXX=test group

 

(for example, MBD/MEM/VID/HDU/FDU

 

/KBD/COM/LPT, and so on), omits the

 

designated test group from testing. (See

 

/IXXX for a list of valid test groups.)

/OALL

The /OALL option omits all test groups from

 

testing. (See /IXXX for more information.)

/IXXX

The /IXXX option, where XXX=test group,

 

includes the designated test group. When

 

used in conjunction with the /OALL option,

 

you can specify the tests that you want to

 

include. These options are helpful if you have

 

insufficient memory available to load all of the

 

test programs simultaneously, or if you want

 

to test specific test groups.

 

The valid test groups are:

 

LPT

Parallel port

 

COM

Serial ports

 

HDU

Hard disk (IDE only)

 

FDU

Diskette drive

 

VID

Video

 

MBD

System board

Chapter 5. Solving Problems 223

Page 241
Image 241
IBM 704 manual Using the Command Line Options, INT10