This soft copy for use by IBM employees only.
*** | Test | your SLIP connection by making sure you can | *** |
*** | ping | the bridge (ping 1.2.3.5). | *** |
************************************************************
Note: You must start TCP/IP (with tcpstart command )before starting Windows.
1.3.2 Chameleon TCP/IP SLIP Connection Setup
After Chameleon TCP/IP is installed, use the CUSTOM application to set
and enable the COM# port as a SLIP interface with the following configuration:
IP Address: 1.2.3.6
Gateway: 1.2.3.5
Modem : direct connection
Modem speed: 19200 bps
Port: COM#
Flow control: ″none″
Note: # is the number of the COM port to be used.
The following statement MUST be added to the WIN.INI file to setup the mtu size.
·TCPIP`
slipmtu=1500
You will need a NULL modem cable if you are directly attached to the bridge using the SLIP interface.
************************************************************
*** | Test | your SLIP connection by making sure you can | *** |
*** | ping | the bridge (ping 1.2.3.5). | *** |
************************************************************
1.4Configuration Utility Program and OS/2 with TCP/IP V2.0
The TCP/IP V2.x for OS/2 must be installed including DOS/Windows access. The latest OS/2 TCP/IP 2.x CSDs must also be applied including the DOS/Windows access CSD.
The TCP/IP SLIP interface must be enabled and configured by running tcpipcfg.
check the enable box |
|
MTU size: | 1500 |
VJ compression: | off |
IP address: | 1.2.3.6 |
destination IP address : 1.2.3.5
The speed of the com port is not set through tcpipcfg. You must explicitly change the com port speed by issuing a mode command from the OS/2 prompt.
