This soft copy for use by IBM employees only.

The result of the latest file transfer.

When one of the TFTP variables is modified, this variable is reset to not-initialized.

When a configuration file is downloaded, the content of the configuration file is checked. If the file is valid and if a reset is mandatory then the atm subsystem is reset automatically.

If the configuration file is not valid or if a reset is not required, the following values are returned in transferResult:

- config-unreadable-version: the control point

does not support the version of configuration file. This configuration file has probably been built

by a further version of control point.

-config-file-empty: the configuration file is not valid

-config-impossible: the configuration file cannot

be applied (internal error, or file corrupted)

-config-internal-error: internal error detected while checking the configuration file.

-config-applied-ok: the configuration file is valid and a reset is not mandatory.″

::= { tftp 7 }

-- Service

service OBJECT IDENTIFIER ::= { node 7 }

-- Traces

traces OBJECT IDENTIFIER ::= { service 1 }

sysTrace OBJECT-TYPE

SYNTAX INTEGER { on (1), off (2)

}

ACCESS read-write STATUS mandatory

DESCRIPTION

When on, the hub general trace facility is started. Messages are stored in the hub in a file that can be retrieved through TFTP.

When off, the general trace facility is stopped and messages are no longer logged.″

::= { traces 1 }

trsTrace OBJECT-TYPE

SYNTAX INTEGER { on (1), off (2)

}

ACCESS read-write STATUS mandatory

DESCRIPTION

When on, the Topology and Routing Selection trace is started.

Messages are stored in the hub in a file that can be retrieved through TFTP.

When off, the control point trace facility is stopped and messages are no longer logged.″

::= { traces 2 }

Appendix E. IBM ATM Campus Switch Private MIBs 225

Page 241
Image 241
IBM SG24-4817-00 manual Description