This soft copy for use by IBM employees only.
−VPI 4 and VCI 10 values are used.
−UNI signalling is set.
−Flow control is disabled.
−ILMI handshaking is disabled, forcing UNI 3.1 signalling.
|
|
|
|
|
|
| |||
8285> | set | port | 3.2 | disable | |||||
|
| ||||||||
| 8285> | set | port | 3.2 | enable vpi_vci:4.10 uni flow_control:off ilmi:off_sig_3_1 |
| |||
|
|
•Configure one PVC between the VDM port and the video source port, either local or remote, using the SET PVC command:
|
|
| |||
SET PVC local_slot.port pvc_id remote_slot.port remote_hub_number path_type | |||||
|
| ||||
| local_vpi remote_vpi bw_alloc bandwidth |
| |||
|
|
| |||
|
|
|
local_slot.port pvc_id remote_slot.port remote_hub_number
path_type local_vpi
The slot and port number for a local end of the PVC.
This allows you to define multiple PVCs per port.
The slot and port number for the other end of the PVC.
The hub number (13th byte of the ATM address) of the other hub. Can match the local hub number for local PVCs.
Specifies the type of virtual path connection.
The vp.vc value for the local end of the PVC. See Table 5 for allowable values.
remote_vpi | The vp.vc value for the other end of the PVC. See | |
| Table 5 for allowable values. | |
bw_alloc | The bandwidth allocation algorithm to be used: | |
| − | BEST_EFFORT |
| − | RESERVED_BANDWIDTH |
bandwidth | The amount of bandwidth to allocate, if bw_alloc has | |
| been set to RESERVED_BANDWIDTH. | |
Table 5. VC Values by Port for VDM Module ( V P = 0 )
Port | First | Second | Third | Fourth | Fifth | Sixth | Seventh | Eighth |
|
|
|
|
|
|
|
|
|
VC | 32 | 33 | 34 | 35 | 36 | 37 | 38 | 39 |
Value |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
With the following command, the video source, an IBM 8300 Video Access Node is directly connected to the 155 Mbps port on the base unit.
|
|
| |||
8285>set pvc 1.13 1 3.2 02 channel 0.33 0.33 | |||||
|
| ||||
|
|
