IBM SG24-4817-00 manual Syntax AtmAddress Access read-write Status mandatory

This soft copy for use by IBM employees only.

SYNTAX AtmAddress

ACCESS read-write

STATUS mandatory

DESCRIPTION

″The ATM address of the ARP server used when communicating

with the switch agent using Classical IP over ATM (RFC 1577).″ ::= { base 4 }

-- base.5 intentionnally left unused

systemState OBJECT-TYPE SYNTAX INTEGER {

reset (1), switch-a (2), switch-b (3), base-only (4)

}

ACCESS read-write STATUS mandatory

DESCRIPTION

″This variables indicates the currently active switch.

When the active switch is in slots 9/10, switch-a is returned. When the active switch is in slots 11/12, switch-b is returned. On a 8285 ATM workgroup, when there is no expansion installed, base-only is returned; when there is an

expansion installed, switch-a is returned.

When reset is set, the complete atm-subsystem is reset and a

switch swap over may occur if the switch electing conditions have changed since the last reset.″

::= { base 6 }

backupMode OBJECT-TYPE SYNTAX INTEGER {

noBackUp (1), primary (2), secondary (3)

}

ACCESS read-write STATUS mandatory

DESCRIPTION

″This variable controls the way the active switch

will be elected at the next reset of the atm subsystem, and controls also the reset of the atm-subsystem.

When set to primary, the switch module currently in use is defined as the primary switch to elect as the active switch, if possible, at the next reset of the atm subsystem. When set to secondary, the switch module currently in use is defined as the secondary switch. If another switch module is present, and can be elected then this

other switch will become the active

switch, at the next reset of the atm subsystem.

noBackUp is returned for the atm subsystems which do not support the redundant switch function.″

::= { base 7 }

functionsConfiguration OBJECT-TYPE SYNTAX INTEGER {

dynamicRouting-noLanEmulationServer (1), staticRouting-LanEmulationServer (2),

Appendix E. IBM ATM Campus Switch Private MIBs 199