This soft copy for use by IBM employees only.
After entering the proper administrator password, you will be logged in, and the 8285 will respond with a welcome message identifying what kind of access privileges (system administrator or user) you have. Figure 36 on page 107 shows the screen containing the initial prompt and the welcome message.
| ||
8285 Nways ATM Workgroup Switch |
(C)Copyright IBM Corp. 1996. All rights reserved. Password:
| Welcome to system administrator service on 8285. | ||
8285> |
| ||
Figure | 36. Logon Screen of the IBM 8285 Console | ||
•SLIP Mode
The setup procedure of SLIP mode console is as follows:
1. Establish normal mode connection
In order to have SLIP mode connection, some parameters are needed, such as an IP address. Then establish normal mode connection at first based on the procedure described in the setup procedure of Normal mode.
2.Set up the console parameters
You need to define local (IBM 8285) and remote (terminal) IP address for the SLIP protocol using the SET TERMINAL SLIP_ADDRESS command. And if you use a baud rate other than 9600bps, change the rate using the SET TERMINAL BAUD command.
3.Change the operating mode
The operating mode of the configuration console is either ASCII or SLIP mode and they are exclusive. You need to change the mode from normal to SLIP since the default setting is normal mode. You can change the mode using SET TERMINAL
The console automatically returns to normal mode if no activity takes place for a period of 20 minutes or if the IBM 8285 resets.
4. Access the IBM 8285
When the previous procedure completed, try to access the IBM 8285. In SLIP mode, you need to start a Telnet session to the IBM 8285. The logon procedure is the same as for the normal mode.
6.3.2.3 Basic Console Functions
This section describes the basic console functions to check if the physical installation has been done successfully.
Te following commands are useful to check the IBM 8285 status:
•
•
SHOW DEVICE
SHOW MODULE
Chapter 6. IBM 8285 Planning and Installing 107
