This soft copy for use by IBM employees only.
8285> set device ip_address atm 9.100.86.150 FF.FF.FF.C01 IP address and mask set
8285> set device default_gateway 9.100.86.1302 Default gateway set
8285> set device arp_server3
Enter ATM address: 39.99.99.99.99.99.99.00.00.99.99.01.01.08.00.5A.99.02.9F.00 8285> save all4
8285> set device ATM_address5
Enter ATM address : 39.99.99.99.99.99.99.00.00.99.99.01.01.99.99.99.99.99.01.00 This call will reset the ATM subsystem.
Are you sure ? (Y/N) y
8285 Nways ATM Workgroup Switch
(C)Copyright IBM Corp. 1996. All rights reserved. Password:
Welcome to system administrator service on 8285. 8285> set port 1.13 enable uni6
8285> show port 1.13
Type Mode Status
1.13:UNI enabled
Starting ping (hit
Ping 9.100.86.130: 1 packets sent, 1 received
Ping 9.100.86.130: 2 packets sent, 2 received
Ping 9.100.86.130: 3 packets sent, 3 received
Notes:
1 Set the 8285 ATM Control Point CIP IP address and subnet mask.
2 Set the 8285 ATM Control Point CIP IP default gateway.
3 Set the 8285 ATM Control Point ARP Server ATM address. This is the address which ARP requests will be sent to to determine the ATM address of other CIP devices.
4 Save the configuration changes before entering the 8285 switch′s ATM address.
5 Set the 8285 switch′s ATM address. This forces a reset of the 8285 switch.
6 Enable the port, port 13, that the ARP server is connected to.
7 Test connectivity by pinging the ARP server.
7.1.3 Troubleshooting Your CIP Network
There are relatively few entities in a CIP network that could cause you problems. However, should you be unable to reach other CIP devices, the following items should be considered:
•Check the ARP server to see that you have registered with it. The procedure for doing so is described below in 7.1.3.1, ªChecking ARP Server for Registrationº on page 127.
