This soft copy for use by IBM employees only.

all the traffic received from the attached line is sent back on this line. If the interface state is not changed, it will automatically go back to the disabled state after one minute.

When interfaceAdminState is equal to wrap-far-end, then the interface located on the other side of the link is now wrapped.

wrap-reply can only be set for 155 and wan ports. wrap-far-end cannot be set.″

::= { interfaceEntry 5 }

interfaceOperState OBJECT-TYPE SYNTAX INTEGER {

unknown (1), disabled-nosignal (2), disabled-idle (3), no-signal (4),

idle (5), in-service (6), pvcOnly (7), failing-internal (8), misConfigured (9), wrongNetworkPrefix (10), wrongNodeNumber (11), disabled-failing (12), failing-line (13), wrap-no-signal (14), wrap-idle (15), wrap-failing-internal (16), wrap-failing-line (17), idle-no-bandwidth (18), idle-internal-error (19), disabled-no-bandwidth (20), wrap-far-end-no-signal (21), wrap-far-end-idle (22), wrap-far-end-failing (23), wrap-far-end-failing-line (24)

}

ACCESS read-only STATUS mandatory

DESCRIPTION

The operational state for this port:

-unknown: the status of this port is unknown (this can

be the result of a module in error)

-disabled-nosignal: no activity is detected at the physical layer while the port is disabled.

If the port is a SSI port, the bandwidth configuration is valid.

-disabled-idle:: activity from the remote device

attached to this port has been detected by the physical layer. The port is disabled.

If the port is a SSI port, the bandwidth configuration is valid.

-failing: an internal hard error has been detected on this port while the port is enabled

-no signal: no activity is detected at the physical layer while the port is enabled

-idle: activity from the remote device attached to this

Appendix E. IBM ATM Campus Switch Private MIBs 209

Page 225
Image 225
IBM SG24-4817-00 manual Description