This soft copy for use by IBM employees only.
Table 32 (Page | 2 of 2). Necessary Parameters for 8285 #1 | |
|
|
|
Parameter | Value | Comments |
|
|
|
ATM ESI | 999999999901 | |
|
|
|
ATM Selector | 00 | Has significance only to local |
|
| workstation. Should be set to |
|
| 00. |
|
|
|
ARP Server | 08005A99029F | |
ESI |
|
|
|
|
|
ARP Server | 00 | Must explicitly match the ARP |
Selector |
| server ′ s value. |
|
|
|
The commands we will need are:
•
•
•
•
•
•
SET DEVICE IP_ADDRESS
SET DEVICE DEFAULT_GATEWAY
SET DEVICE ARP_SERVER
SAVE ALL
SET DEVICE ATM_ADDRESS
SET PORT
The reason why SAVE ALL precedes SET DEVICE ATM_ADDRESS is that the latter forces a reset of the ATM subsystem. You will be warned first, but if you forget to save the parameters you have just entered, they will be lost; only the ATM address will change.
Below is an annotated transcript of the commands used to configure and test our simple network.
Chapter 7. IBM 8285 Configuration 125
