IBM SY44-5902-05 manual Following table, Function Description Range

following table.

Table 10. Data collection ranges for Models 150, 170, 250, 4xx, 50x, 51x, 530, 53S, 6xx,

7xx, SB1, and Sxx. Functions 54 through 58, 63, and 64

Function	Description	Range
54	I/O configuration table	5400, 5401, 5402...continue until
		you get 0000 0000 two times or FF.
55	Service Processor (SP) card log	550A to 5518
	buffer
56	SP™ code area	5600 to 56FF
57	IPL message save area	5700 continue until you get 0000
		0000 four times or FF
58	IPL parameters area	5800 to 5808
63	Status SRCs trace	6300 to 6318
63	Final status SRC only	6318 to 6320
64	Diagnostic status SRC trace	6400 to 6420
64	Final diagnostic SRC only	6418
64	All words of final diagnostic SRC	6418 to 6420

Use the following procedure and record the data as shown.

1.Press the Increment (↑) button until the function you want appears in the Function display (example: 54).

2.Press Enter on the control panel; ** appears next to the function number to indicate that you are in the subfunction mode. This is the entry point and exit point for subfunction mode).

If the data is xx _ _ _ _ FF (where xx = the function number), this function is not available.

3.Press the Increment (↑) button until 00 is next to the function number.

4.Press Enter on the control panel. Data appears in the display. Record the data.

5.Press the Increment (↑) button to continue to the next subfunction (example: 5401).

6.Press Enter on the control panel. Record the data.

7.Repeat steps 5 and 6, increasing the subfunction number one at a time and recording the data until all the suitable data is collected.

8.Press the Increment (↑) or Decrement (↓) buttons to move from the last subfunction back to ** (example: 543F to 54**).

9.Press Enter on the control panel. Doing this takes you out of subfunction mode, and ** no longer appears.

Repeat steps 1 through 9 for additional data that you were instructed to collect.

Call your next level of support and give them the information you collected to write a LIC APAR.

Displaying data for functions 57, 63, and 64 (Models 270, 8xx, SB2, SB3, and 890)

Use this procedure to collect data. Each function has a different amount of data to collect. Collect the data for the range that is listed for each function in the following table.

132Service Functions V5R2